26 Apr. 21

4 Hot Water Heater Repair Near Me Tips

Water heater repair near me is a troubling issue to deal with. Things can turn suddenly and require immediate attention. Burst valves,

heat element problems, or any other number of issues could pop up at any time. 

Like any piece of constant-use machinery, your hot water heater has a lifespan. When getting on in years, you will see a definite change in efficacy and efficiency. This can potentially be when you notice faulty parts or performance issues, and lead to needing to call water heater repair (near me).

Luckily, there are some great maintenance tips to stay ahead of the game and to ensure that your heater has the most longevity and efficiency as possible. Some of these may be a one time fix, others may require some diligent monitoring and adjustment. Let’s take a look at some of the most effective ways you can be helping your water heater stay healthy and maybe even get a few more seasons out of it. 

Turn Off Power And Test Electronics

In most cases, the first step should be assessment. If you can narrow down the issue at all, start there. If not, a good place to start is cutting power to your machine. These are high-powered devices that carry a significant danger to work on or test the electrical components unless the power is cut. Before checking any electrical component, turn off the power supply to your heater at your circuit breaker. 

Once safe and confirmed that it is turned off, you can test connections and wiring for breaks or faults. If you are not prepared to do this, call a repair service to come assess things. 

Test Your TPR Valve

Your hot water heater will have what is called a Temperature Pressure Release valve. There are a few steps you can take to test this valve. Shut off the power and turn off the cold-water supply to your tank. If this valve is having issues, this repair is simple enough and doesn’t necessarily need the added cost of plumber. Place a bucket under the pipe connected to your TPR valve and then lift the tab to drain some of the water. Drain the tank partially, remove the valve with a pipe wrench and replace with a new piece. This installation is not difficult. 

As with all home repair or prevention however, assessing the severity is always important, and always call a San Antonio plumber if you are uncertain. 

Test Your Heat Element

If you aren’t getting hot water, this could mean a faulty heating mechanism. There are a few steps you can take to diagnose this. If your breaker has tripped, flip it off and on again. If it has not, there is a high-temperature cutoff reset button you can access behind the upper heating element panel. This can be a potential fix, but if it does not work, replacing the heating elements may be the next step. The cost of plumber may be well justified. 

Check Thermostat Settings

Not enough hot water or water being too hot can be a serious problem and in either case it is possible that one or both of your heaters’ thermostats are set wrong. The recommended heat setting for both thermostats is between 115 and 125 Fahrenheit. Both should be at the same temperature. Adjusting both thermostats with a flat head screwdriver to be the same value in the correct range may solve the problem. Do not attempt without the proper safety precautions and electrical safety. 

When in Doubt Search for Water Heater Repair Near Me

Assessment is half the battle, and troubleshooting can be just as important as early detection. Rust colored water, tank noises, corrosion leaks, and so many other issues may require more immediate professional assistance from a water heater repair near me. When in doubt, call a San Antonio professional today. 

For more information about water heater repair near me and cost of plumber in San Antonio visit, https://peopleschoiceplumbingtx.com/